1 / 2
DnD Money Counter Tool — zdjęcie 1
1 / 2

DnD Money Counter Tool

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows for keeping track of the parties (or individual players) gold in DnD, but can also be used to count anything else

Ocena
5 / 5
Polubienia
200
Pobrania
445
Wydruki
3
Wyświetlenia
3550
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Description

This is a money counter for DnD or other tabletop games. Each digit sits on a pretty satifyingly clicky spring while the end caps are designed to be nice to hold and nice to look at. 

The counter caps out at 10 Million gold pieces if a copper and a silver counter is used aswell, but if it is printed to only count gold it can go up to 1 Billion gold pieces. In both cases it should be more than enough for typical games though. 

Print Settings

All pieces print fine at 0.2 layer height, although for better surface finish on the caps and wheels I went with 0.1 instead. No supports are necessary for any part.

Assembly

To build the full counter, you need:

  • 2 Caps on each end
  • 1 Pin to connect both caps
  • 7 Springs
  • 7 Wheels
  • about 3 Spring discs

All pieces are designed to be a snug fit on my printer, so if you feel them being to tight or loose, you may need to fiddle around with the sizing.

To assemble the counter, start by pressing the springs into the wheels. It is normal that this takes a bit of force as the springs have a ridge in the middle to keep the wheels centered once assembled. 
 

Important!

The springs have a very small offset on one side to keep the wheels from rubbing on each other once assembled fully. For this to work correctly, make sure to always put the wheels onto the springs in the same orientation.

Once all wheels are assembled, put the pin in one of the caps and then slide on the assembled wheels. Again check that the orientation is correct in this step. Because tolerances are difficult with 3D Printers, also use some spring discs to evenly space out the wheels. In my case, I used 3 (1 between copper and silver, 1 between silver and gold and 1 between the final gold piece and the end cap), but it might take some trial and error to get the perfect amount to have the second end-cap fit on snugly.

Tagi