Slotket retention clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small retention clips for putting a slotket in a Slot 1 CPU mount.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 203
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
I made this to make my Slotket less wobbly after the original retention clips broke. This worked specifically for me on an ASUS P2B 1.10 where are there runners on the side of the Slot 1 mounting arms - not all have these, so the grooves may be unnecessary. The tolerance to hold the slotket board itself is quite tight, so just be aware of that. The grooves to grip the slotket are slighly offset - that's what worked best for me, you could always make adjustments to make them central.
I printed on 0.12 Fine setting using PLA, heat shouldn't be a concern where this contacts the board. I used a brim, but you may get away without using one.