1 / 3
Filtered Fume Extractor - Flow Update
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This fume extractor gets rid of unwanted fumes!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 36
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Standard Digital File License
Portable Fume Extractor V2
-
Air Flow Update
Finally, V2 is out and it is better than ever! This update focuses on optimizing the air flow to increase sucking power!
Key Features -
- Removes harmful fumes
- Simple to use
- Uses 70mmx70mmx15mm PC fan
- Compatible with X1 & P1 series filters. (Optional VoxelPLA filter for HEPA)
Changelog -
- Optimized internal airflow path — re-contoured channels and baffles to reduce turbulence and direct more volume through the filter.
- Fixed model error where X1 and P1 filters would not fit
- Universal filter adapter included — fits X1, P1, and VoxelPLA filters without modification.
- Increased vent aperture — larger vent holes for higher throughput and lower backpressure.
- Directed fan placement — added fan well to reduce air recirculation
- Improved sealing / air separation — upgraded baffling and gasket geometry to minimize unfiltered bypass.
- Extended cover — longer cover geometry prevents “skimming” flow that allows fumes to travel around the filter.
- Wire-vent plug — simple plug to close the fan-cable vent and reduce leakage and contamination paths.
Enhanced filter grip inserts — larger gap to allow for less exposed grip
Assembly -
- Pull fan wires through wire hole of fan cover
- Place fan into fan cover using the three guide rails (ENSURE THE FAN IS IN THE CORRECT ORIENTATION OR IT WILL NOT WORK)
- Lock wires into place with the stopper
- Place air flow tunnel (Ensure it is the correct one for your filter) on top of fan so that it is fully covered. (For most fans this should be the square side)
- Place filter into Filter cover
- Insert pull tab into the gap between the side wall and filter (it should directly align with the pull tab)
- Place Filter cover onto fan cover
The steps following this will be different for everyone since it depends on your wiring needs.
- Connect DC adapter to the ground and the power of the fan
- Plug into the wall
- Optional use of a switch.
⚠THIS MODEL CONTAINS ELECTRICITY. BUILD AT YOUR OWN RISK ⚠