1 / 3
Ubiquiti Unifi G6 Instant Camera Rain Shield Enclosure for Floodlight Cam — zdjęcie 1
1 / 3

Ubiquiti Unifi G6 Instant Camera Rain Shield Enclosure for Floodlight Cam

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of Ubiquiti Unifi G6 Instant Camera Rain Shield Enclosures for Floodlight Cam

Ocena
0 / 5
Polubienia
9
Pobrania
59
Wydruki
0
Wyświetlenia
913
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Created this remix of linked OP to provide more cover and suit my needs to make a G6 Floodlight Cam since Unifi doesn’t. I made several variations of the OP’s design, the first (which I used and does work perfectly) is a 4 mm longer version to provide a longer lip for rain/weather protection, without obsrtucting the view. I also made two 10 degree slope cut versions with the length of 10mm longer to provide more sun & weather proection in a roof format. I haven’t installed these as I’m at my camera limit and only made it after finishing the project. Links below to the remixes I made (4mm longer, 10mm slope in normal orientation, 10mm slope in an inverted orientation & a full 10mm longer version for you to chop up however you want. I’d assume it will obstruct the view with a border if you don’t chop the full length one. (Plan to test more once I get an NVR to expand, I’m at my camera limit lol).  

Links below for things used, use the link for the floodlgiht as there are like 7 versions of this thing. Ask me how I know…. I also used a thick and short USB-A to C cable but needed to manually trim the corner housing of cable to close the camera lid. I’ve also linked to another one that others on Reddit recommended but haven’t tried yet to confirm). Lastly, I used white silicone to seal up the back once I finished the install to prevent any water ingress (especially since I mounted it inverted).

Printed on Draft settings (.28mm) with 4 perimeters (no infill) in White PETG on a Prusa XL with a 0.4mm ObxHF Nozzle for reference.

Floodlight: https://amzn.to/3VDeFDw

USB Cables: https://amzn.to/3JNoLzc (Tested, but requires trimming to fit) https://amzn.to/3JRC9Cp (Not Tested, but will eventually try it on the next one, as others report it works on Reddit.)

Video that inspired me: 

Tagi