Clicky Clack Fridge Door remix for MGN12 Y and Z rails on Voron
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix parts for Clicky Clack Fridge Door if you use MGN12 rails for the Y and/or Z rails on Voron
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 470
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
In the situation where you are using MGN12 rails for the Y and/or Z rails, the extra width of the carriage means you need to space out the acrylic side panels.
A common technique is to use 5mm thick EDP adhesive tape instead of the 1mm tape. However if you do this then the door handle cannot be fitted as it fouls on the side panel.
This remix adds an additional 4mm of clearance to the latch and handle parts, allowing for the thicker tape. The bolt holes are recessed 4mm so that the original mounting hardware can be re-used.
Printing: Make sure the handle-hinge top and bottom files are flipped on the build plate, flat side down, in order to print without supports. I kept the same orientation as the original STL files, which also need to be flipped to print properly. The latch prints as-is, on its end like the original, and somehow it doesn't seem to need supports.