Voron Trident router templates for acrylic panels
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A set of router templates for shaping the acrylic panel cutouts from simple rectangular cut sheets.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 181
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Introduction
The problem with the Voron panels is that most of them have cutouts of
various shapes and sizes, only the top and sides are plain rectangles.
To get panels of the correct shape, you need to have them CNC cut.
However it is much cheaper to get them saw cut to size as a plain
rectangle. Then you can add the Voron specific cutouts manually.
The saw marks can also be cleaned up with a few grades of sandpaper.
In order to make the cutouts as neat an accurate as I could, I designed
these templates that you clamp to the acrylic sheet. You then use a
trim router with a bearing bit (get the narrowest you can find) to
follow the contour of the template. There are locating protrusions which
touch the edge of the sheet.
Rear Panel
The exhaust exit template is positioned centered on the top edge of the
panel. There is a mark for the center, which you can align with a
center mark drawn on the protective cover for the sheet.
Bottom Panel
The corner template has a mark indicating the front and rear
directions. This cutout is not symmetrical, so first establish which edges
of the sheet are the front and the rear (you can mark them on the
protective cover) and position the template accordingly. You will need
to flip the panel upside down to use the template for the other side.
The screen template is positioned centered on the front edge of the
panel. There is a mark for the center, which you can align with a
center mark drawn on the protective cover for the sheet.
Deck Panel
The left/right front motor mount template. This cutout is symmetrical so use
any orientation so long as you get the 2 front corners.
The rear motor mount template also includes the cutout for bed wiring.
There is a mark for the center, which you can align with a center mark
drawn on the protective cover for the sheet. Note that this template is
not symmetrical, so ensure that the cutout for the bed wiring is to the left
of the larger motor cutout.
The left/right rear cable corner template for cables. This template is
not symmetrical so ensure the alignment mark points to the rear. You
will need to flip the panel upside down to use the template for the other
side.