M4 Mac Mini 10 Inch Rack 1U Front (1.3U Rear)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Install Mac Mini M4 in a 1U slot in a 10" rack as long as the slot below it has about 1 cm of headroom. Very crude model
- Ocena
- 4 / 5
- Polubienia
- 9
- Pobrania
- 57
- Wydruki
- 1
- Wyświetlenia
- 807
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Reduces height of the front to only take up 1U of space (45mm). From there it gradually expands to the original height (52mm). For this reason, whatever you place below it in your rack should have at least 10 mm of headroom to account for the added thickness and airflow. It's great for placing over network switches.
Towards the back I created a cutout to ease removal. I found that I needed at least 1U of headspace in order to remove the Mac Mini, so I added a notch in the back that requires only about 7 mm of lift in order to remove the Mac Mini. Even with the cutout, it still holds the Mac Mini very securely, you could probably reduce it by another couple mm if you wanted.
I made these modifications using TinkerCAD because I'm a dummy and it's the only CAD I know. For this reason, the model is fairly crude. I'm sure that someone could probably jazz it up a bit and/or apply these modifications to the lightweight versions of the model as well.
The cutouts alone save a ton of weight. My original print took 96 grams of ABS, this one with all the same settings took 75 grams. It also reduced the total print time from 2h40m to 2h10m which is nice. (I'm printing in Creality Hyper PLA on a Creality K1)