Apple iPhone Magsafe Stand - Wide Base - Standby Mode compatible - requires M4 screws
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My goal was to make a less annoying stand, so the magsafe puck doesn’t pop out when I pull the phone off
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Goal
My goal was to make a less annoying stand, so the magnet (puck) doesn’t pop out when I pull the phone off.
This design trades a bit of minimalism for a wider, more stable base and a screw-together front plate that keeps the puck seated.
Compatibility
Designed for round MagSafe-style pucks that measure Ø 56.0 mm and ≤ 5.5 mm thick.
Tested with Apple 15 W puck; Apple 25 W puck also should fit.
Many Qi2 third-party pucks are ~60 mm OD and will not fit. Measure before printing.
Magnetic hold
The front face of the puck holder (between phone and puck) is 0.4 mm thick.
That thin layer slightly reduces magnetic hold vs. a bare puck. It still holds your phone.
For best results: use a phone case with a MagSafe ring for a stronger hold
Files:
- puck holder — front
- puck holder — back
- stand — front
- stand — back
- feet — optional (TPU?)
parts 1 and 2 are connected with 4 × M4 × 6 mm screws
2, 3 and 4 should be connected by 8 × M4 × 20 mm screws
each foot should have 1 × M4 × 6 mm screws
Notes: Screws are meant to bite directly into the plastic threads. Washers not required.
Materials
PLA or PETG for the main parts
TPU feet (optional) for grip and vibration damping — the stand works fine without them
optional: print the front half of the puck holder in TPU for a softer feel
Printing
Nothing special - your usual settings should be fine
Order: Inner→outer
No supports needed.