1 / 2
"Rug saver" brushes for Tesvor M1 / X500 robot vacuums (compatible to Mamibot, Neatsvor) — zdjęcie 1
1 / 2

"Rug saver" brushes for Tesvor M1 / X500 robot vacuums (compatible to Mamibot, Neatsvor)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modified brushes for Tesvor vacuums, which prevent the robot from curling up light weight rugs and carpets.

Ocena
0 / 5
Polubienia
21
Pobrania
48
Wydruki
0
Wyświetlenia
1048
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Living Room
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Modified brushes for Tesvor vacuums, which prevent the robot from curling up light weight rugs and carpets. The original brushes on Tesvor vacuums like the M1 or X500 are using bend down brush bundles, which cause the robot to sweep under light weight rugs and carpets, curling them up and resulting in a stuck robot. These modified brushes have less bend in them, preventing the brush bundles from being forced under the carpet.

Tested and working on a Tesvor M1 for over 4 years. The brushes likely work with any recent Tesvor vacuum, since they all use the same spare parts. Since the Tesvor vacuums are identical to some models under the Mamibot and Neatsvor brands (e.g. Neatsvor X500), you can check if the brush savers fit those, too. I'm using the “straight” brush type, but a design with angled brushes is also provided. Use what works best for you.

Each brush requires three M2x6 mm machine screws to assemble. Truss head or dome head screws work best. The brush bundles are simply cut off at the base of a regular replacement brush. I've added thin double sided tape to each brush stem during assembly, but a drop of white wood glue or Gorilla glue will probably work, too. The brushes work without the tape or glue, but a bundle might occasionally slip out in that case.

Print settings

  • Layer height 0.1 mm

  • Line width 0.4 mm

  • 4 wall lines

  • 6-7 top & bottom layers

  • Supports and support interfaces on

The material should be as stiff as possible, because the “bottom” part is relatively thin. Regular PLA works fine, but PLA-CF, PC-CF or similar materials might be even better.

Tagi