Dry Ice Blaster for Optics Cleaning
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printable dry ice blaster for cleaning sensitive optical components.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The blaster needs to be supplied with compressed nitrogen gas or dry air with a pressure of roughly 80 psi. The air flow is split into a high-pressure and low-pressure (20-25psi) line with a secondary gas regulator. A trigger mechanism controls the high-pressure line. Fine ground dry ice is loaded into the top reservoir of the blaster. The trigger mechanism requires some non-3D printed items listed below.
Bill of materials:
-2x 8-32 screws
-2x 8-32 square nuts
-Crushed dry ice
-Compressed dry air or nitrogen gas
-Gas pressure regulator (~80 psi)
-Low pressure gas regulator (20-25 psi)
-¼ in soft plastic tubing for gas input
-One ¼ in push-to-connect t-connector
-Compressed air filter
-2x (5x15) mm compression springs
-One (2x8) mm metal/wooden rod
2 spring rods are required for assembly.