Anker Model A2063 6 port USB under desk mount (PowerPort+6 with Quick Charge 3.0)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount an Anker USB Charger under your desk with a 25 gram two piece bracket. Supports Model A2063 PowerPort+6 QC 3.0 USB
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 132
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Mount an Anker USB Charger under your desk with a 25 gram two piece bracket. Supports Model A2063 PowerPort+6 QC 3.0 USB. Uses 25 grams and about 1 hour of print time (PETG). Rounded fillet corner design prevents charger from sliding out forward or backwards. Stays locked in place.
- Print material: PETG
- Print Settings: 6 Walls, 5 top layers, 9 bottom layers (This should achieve 100% infill). A 3mm Brim is optional.
- Mount by drilling 4 Counter sunk wood screws under your desk.
Note: There is a Front piece and a Rear piece. The USB charger is not completely square. It is 2mm taller and wider in the front relative to the rear measurements. If possible, use a caliper to measure the dimensions of your Anker A2063 USB charger to see if these measurements match with yours:
Front: 78mm wide, 29mm tall.
Rear: 76mm wide, 27mm tall.
Your specific Anker charger may or may not share the same measurements. If needed, you can use two front or two rear pieces and the mount should still work.
I have included the Fusion 360 .f3d project file for your own modification needs.