Philips EE2000 series base board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reproduction of the base board used in the EE200x electronic engineering kits. This kit was sold in the 70-80s
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I make this reproduction of the base board used in the EE200x electronic engineering kits. This kit was sold in the 1970-1980s, and then later by others in different form in the 1990s.
It is the base board used to put electronic components on with use of springs and clips that allows you to make many different circuits. Philips' kits were far more elaborate than the 103 or 200 circuits that use wires to a few components. They has a thick manual that explained the function of electricity and the components in detail.
You can use the base boards with the spring to actually make and test your own circuits and it was useful before the age of breadboards. You can almost layout the circuit like you draw it.
It prints on printers of 230 mm or larger. I have use the anycubic chiron and later the elegoo centauri carbon. The print is superb on the elegoo.
I have used no support apart on 2 holes which I use as the exterior sides (because it's closed off), but these can be pushed out easily.
Anyway this is the baseboard for it. I also have replicated the tuning knob.