Ender 3v3 Coprint X carriage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Coprint x carriage for ender 3v3. SENSORLESS HOMING REQUIRED.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 203
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Homing will use one of the screws used to mount the belts to the carriage. Use a socket head cap screw on the hole AWAY from the pulley on whatever side you home with. Use a low profile button head cap screw on the opposite hole.
If homing to max x position (right while looking at the printer), Socket head screw closer to the front of the printer. If homing to the minimum x position (left looking at the printer), socket head screw towards the rear.
See pictures for positions of the socket head vs button head locations. (Shown is old version. Grey tensioner on the rear is replaced with just 2 screws on left and right, similar to the bottom bearing)
Use LIGHT pressure on the bearings to hold them. Confirm with input shaper to make sure bearings are snug and held in place