Meshtastic Heltec T114 and 18650 Mobile Node
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A prototype of a mobile/pocket node for the Heltec T114 LoRa board with an 18650 battery.
- Ocena
- 4,667 / 5
- Polubienia
- 67
- Pobrania
- 494
- Wydruki
- 4
- Wyświetlenia
- 3691
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple mobile/pocket enclosure for a Heltec T114 board with an 18650 battery. Most models place the battery behind the board, resulting in a bulky enclosure. This is about as compact as possible. Assembles with eight M3 heatset inserts and screws. There is accommodation for a bulkhead SMA connector, but could also be modified to use an internal antenna.
This is functional as is, but could use a few tweaks. The M3 holes in the end plates could be slightly larger t allow for some tolerance. They could also be made thicker to help hide the SHCS heads. I plan to revise it with some sort of texture/features, purely for aesthetics.
Dimensions are quite tight, so you should have a well calibrated printer for everything to fit correctly. I set my print profile up using a Califlower, and am able to assemble and everything fits, but it is snug (by design).
No supports needed, just place everything on the bed and let it print. I use a 0.16 layer height, but 0.24 would also work just fine.
I've prototyped this with PLA, and it works fine, but for ones in daily use I've been using PETG-CF, which is rugged, and has a nice matte surface finish. You want a filament with a bit of flex for the buttons to work.