Thrust Tube Former for TopRC Odyssey TPU Wrapping Bands
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
TPU Wrapping bands to hold the laminated sheet in place during joining
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 37
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Tapered conical TPU wraps to hold the 0.25mm laminated carbon sheet cut to match the conical shape of to the Thrust Tube Former whilst joining it with a carbon cloth strip (I used a 6cm wide strip).
As a tip, write down every sequence number on the wrapper and an arrow indicating the bottom so that when you are going to use them you know in what direction the taper is going and what sequence number you are using, makes it easier and less stressy when epoxy curing time is of the essence.
I cut them all on one side and removed a few millimeters so that they are open bands with a gap, then I spray the inside of the TPU with silicon grease spray, not really necessary as TPU is non reactive to epoxy but just to be sure to not have a -wtf- moment when taking it apart in the end. Lay down the center of the TPU wrap over the richly impregnated carbon cloth strip and use blue painters tape to tape the TPU wrapper as firmly as possible around the tube, this gives, to me, the best result.
Printed in vase mode on a 0.6mm nozzle, 0.32mm layers with SunLu 95A White TPU, choose whatever TPU you like but this one really does the job for me, the transparency helps with checking the dispersion of the epoxy.