1 / 14
Three-wing star knob for Screws and Nuts (M4, M5, M6 or M8) — zdjęcie 1
1 / 14

Three-wing star knob for Screws and Nuts (M4, M5, M6 or M8)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Three-wing knob, easy to tighten with gloves. Two lid versions, snug nut fit. Variants: M4, M5, M6 or M8

Ocena
5 / 5
Polubienia
57
Pobrania
502
Wydruki
4
Wyświetlenia
1081
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This design was originally made for my lawn mower, which has some quick fasteners that don’t work very well. I wanted a knob with only three wings so it can be tightened easily while wearing gloves. I’ve uploaded two versions of the lid: one with a through-hole and one without (see .step file). The nut fits very snugly. If you can’t press it in by hand, simply use a screw with a washer to pull it into place inside the knob. 

Select between knob suitable for: M4,  M5, M6 or M8

Print settings used: 

  • Layer height: 0.2 mm (structural), 

  • Material: PETG Infill: 25%

  • Perimeters: 3; Top layers: 5 ; Bottom layers: 5. This results already in a rather sturdy knob, but feel free to adjust

  • No supports needed

  • Print with the shaft of the knob placed on the print bed

Tagi