1 / 2
Compact Hemera Mounts for 40mm fan, 18mm and 12mm probes, filament sensor, and HyperCube carriage — zdjęcie 1
1 / 2

Compact Hemera Mounts for 40mm fan, 18mm and 12mm probes, filament sensor, and HyperCube carriage

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a set of mounts I designed for mounting the E3D Hemera to my HyperCube build.

Ocena
0 / 5
Polubienia
4
Pobrania
81
Wydruki
0
Wyświetlenia
1158
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a set of mounts I designed for mounting the E3D Hemera to my HyperCube build.

The blower fan and probe mounts should be compatible with any other printer if you'd like to mix it with another carriage design.

Included parts:

  • 12mm probe mount.

  • 18mm probe mount, e.g. the EZABL.

  • Filament sensor mount, with holes for optionally attaching an drag chain. Also included text for multi-material printing.

  • 40mm print cooling fan mount. This part sits very close to the heat block, printing in ASA/ABS is recommended! PETG also probably works, but I haven't tested it.

  • Carriage mount for the original HyperCube. I can probably figure out EVO mounting holes if there's interest.

M3 screws needed: 6mm x2 (probe), 8mm x 4 (blower), 10mm x4 (carriage), 25mm x2 (filament sensor)

Print instructions

Print the blower fan in ABS, ASA, or another material that can handle heat well. PETG may work, but is untested.

Tagi