Google Pixel 10/10 Pro Case with PixelSnap Magnet Pocket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of the Pixel 10/10 Pro Case from @gleonard3 which has a pocket for magnets and a modifier block for retention
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 72
- Wydruki
- 1
- Wyświetlenia
- 779
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
Based off @gleonard3's Pixel 10/10 Pro case to add a small pocket to use a set of magnets and a body that can be used as a modifier to add top/bottom layers to the pocket so the magnets don't slip out.
This model is intended to be printed in TPU, as gleonard3 noted in their original model.
Magnets I used: https://www.amazon.com/dp/B08Q7XWB85
I stacked both sets of magnets on top of each other before embedding into the print.
15% Honeycomb infill has been the sweet spot for me.
Insert a pause at Layer 15 (if using 0.2mm layer height) to embed the magnets.
The .3mf file should have these settings applied already, if not make sure it's a modifier type body with those settings applied.
Under the overall print settings, Top and Bottom Solid Layers should be set to 0.