1 / 1
VZBOT:Dragon UHF 40mm fan duct with HEX-NUTS
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dragon UHF 40mm fan duct with HEX-NUTS, not heatserts mainly for the printed vzbot.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 179
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Dragon UHF with a 40mm fan duct with HEX-NUTS, not heatserts mainly for the printed vzbot. I printed it in resin like I do for most of my printer parts normally.
GPT tells me it's better not to cut vent holes on the sides so that more air pressure goes through one end and out the other.. You tell me(Ill run simulations eventually in NX and rhino). Thinking of modeling a couple holes in if there's any clogs. 25mm fan wasn't cutting it.
