KK2.1 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
UPDATE -4/23/2013, Added a case with no buttons. 2/19/2014, Night: Updated case on thin section between the hole and…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 148
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
UPDATE
-4/23/2013, Added a case with no buttons.
- 2/19/2014, Night: Updated case on thin section between the hole and the buzzer port, and removed two holes near them. Improved alignment of buzzer port and voltage port.
- 2/19/2014, Morning: Screw holes on the old base did not go all the way through, I used a drill to drill them out. I updated the design to have proper holes.
Changes from 3dxl KK2.0 case design:
Flipped the case upside down because I did not want to print supports. Unfortunately you loose the little notches on the buttons, but I found I could still press them easily.
Changed the clipping and swivel of the case on the base to a screw fit. I used #6 bolts from Home Depot.
Changed the screw layout on the base to fit this design: http://www.thingiverse.com/thing:32281
Added holes for the KK2.1 board buzzer and battery power port on the case.
I did not change the lid at all, but I left a screw hole in the middle of the base so that this could easily be changed. I do not use a lid on my quadcopter.
Enjoy!
Category: R/C Vehicles