Rock Shox Reverb vent tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vent tool for RockShox Reverb, print your own replacement.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 65
- Wydruki
- 1
- Wyświetlenia
- 314
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Public Domain
This is a 3D printable replica of the official RockShox Vent Valve Tool (part #TL-RVBT-VNTV-A1), designed for quick and easy maintenance of RockShox Reverb dropper seatposts. The tool allows you to activate the vent valve without disassembling the post, helping to purge excess air that may cause "squish" or unintended compression (beyond the normal 5mm). It's essential for restoring firm extension on affected posts.
Compatibility:
- RockShox Reverb AXS (1st generation and later)
- RockShox Reverb Stealth C1 (2020 models and newer)
Print Settings:
- No supports required; prints vertically (as per pics).
- Recommended: 0.2mm layer height, >20% infill.
- 4 walls, 5 layers.
- Material - dealers choice, I printed in ASA, but most materials will be fine.
Usage Instructions:
- Remove the seatpost from your bike and place it on a flat surface.
- Locate the vent valve at the base (near the lower air chamber).
- Insert the tool firmly into the valve and apply gentle pressure until it seats (about 2 seconds).
- Cycle the post (extend/retract via remote) to vent air.
- Press down on the post head to repressurize, then reinstall.
For full procedure, refer to RockShox's official AXS Vent Valve video or C1 Vent Valve guide. Not for regular use—only when squish is detected. Happy printing and wrenching! If you experience persistent issues, a full rebuild may be required.