1 / 10
Tesla Model 3/Y Pads for Lifts, Floor Jacks and Jack Stands — zdjęcie 1
1 / 10

Tesla Model 3/Y Pads for Lifts, Floor Jacks and Jack Stands

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Pads for floor jacks and jack stands for Tesla Model Y and Model 3 with single 25mm (~1 inch) diameter jack point holes.

Ocena
0 / 5
Polubienia
10
Pobrania
56
Wydruki
0
Wyświetlenia
323
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

These pads are used to protect the frame and battery on Tesla Model Y's and Model 3 's from jacks and lifts. This design works on vehicles generally made before 2023 that have a jack point hole diameter of 25mm. According to Google, Tesla changed the hole diameter to 20mm starting in 2023 however some vehicles may still use the 25mm hole so if unsure about your vehicle it is just best to measure.

My design is similar to the variety of aftermarket ones you can find on Amazon though they tend to be made either from rubber or TPE (kind of a super hard rubber like a hockey puck). The solid one is designed for floor jacks while the slotted one I designed to fit my ancient pair of Mack Jack Stands model 9334. The “Y” support of these jack stands is fairly common to many of these inexpensive 2-3 ton units found at Harbor Freight and auto stores. Both of these pucks have a groove in the 25mm stud for an o-ring that will hold the puck in place on the vehicle so you can get your jack lined up - just don't forget to remove the puck before you drive!

I printed the jack stand version in PETG using 50% infill with a triangular infill pattern, 6 wall loops and 2.5 mm top and bottom shell thickness. The jack stand version with the slot cutout in the middle will need to be printed with supports and both of these should be sliced/printed with the 25mm knob pointing up to ensure that they have compressive strength in that direction!  I didn't print the non-slotted version but I did use the jack stand version on both a floor jack and a jack stand several times and it worked flawlessly without any cracking or distortion of the puck.

NOTE: I did this as an quick academic exercise for the fun of the design and to see if 50% infilled 3D printed versions of these materials had the compressive strength to handle these loads. In theory PETG has compressive strength of up to 80MPa (~11,600psi) implying at the most basic level that a solid puck with a 1 square inch “face” made of PETG could easily support my whole vehicle (Google says 4416 lbs for the 2022 Model Y Performance) However, compressive strength is highly dependent on MANY factors and I did not intend for this to become a science project!  Bottom line is don't print these things to save a few bucks unless you just are curious -  go and buy properly engineered pucks made from solid materials - they only cost $20-$30 for a set and even might come in a nice little case!

DISCLAIMER: Print and use these at your own risk as failure of these parts under load will likely cause significant damage to your vehicle and/or cause serious injury or death if you are near or under the vehicle.

Tagi