TA01 Chassis

This chassis was built to mount squared LiPo batteries with maximum dimensions of 47(W) × 27(H) × 135(L) mm. The chassis turned out lighter than the original, surprisingly.

The battery holder is mounted to the main chassis using 4 × M3 × 5.7 mm (length) × 4.6 mm (OD) threaded brass heat inserts and M3 × 8 screws. The hook on the battery holder is meant to secure the battery balance connector.

I have created some built-in supports for the screw head holes on the bottom of the chassis to make printing easier.

I recommend using 3–5 perimeters to make the chassis more solid and crash-resistant. All prototypes were printed with PETG.

There are 2 variations of the chassis available in the download section:

• The whole chassis in one piece + battery holder

• First version, which broke easily after a frontal impact due to a low number of perimeters (the prototype had only 2 perimeters).

• Main chassis with removable front diff mount + battery holder

• This modification was made after a frontal impact caused the front diff mount to fall apart.

• The front part needs some slicer-generated supports because of the overhang.

• I recommend printing this part more fragile so that in case of impact it will break more quickly than the rest of the chassis (e.g. 2 perimeters).

• Requires 5 additional M3 × 5.7 mm threaded inserts + 5 × M3 × 8 screws.

 16-07-2026: updated reinforced batt holder, as in the original design the battery was able to break the side barrier