Retaining clip for 5.5mm rod or mesh panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clip sized to fit a 5.5mm bar. I've used some of these to hold a blackberry trellis up.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 65
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Retaining clip to hold a mesh panel (called a hog panel at the store) up and use it as a trellis. This fits snugly on 5.5mm diameter mesh/bar. Could also be used for wires or cable.
I printed them (flat side down, no supports) in ASA for strength and UV resistance. They've only been installed for a couple weeks, so we will see how they do with time. For strength, I printed with 4 perimeters and adjusted all layers “above” the hole for the wire to be solid.
This is probably a pretty niche application, but thought I would share it anyway.