Both Sides Beehive Starter Strips - 5.0mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple remix of guppyk's 5.00mm starter strips. I duplicated the model and combined them back-to-back so…
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 181
- Wydruki
- 1
- Wyświetlenia
- 1038
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is a simple remix of guppyk's 5.00mm starter strips.
I duplicated the model and combined them back-to-back so that the cells are on both sides of the strip. The extra thickness allows these to be printed standing up. These slipped snugly into langstroth frame tops from Mann Lake. I will be using these as frame inserts in swarm traps to capture potential swarms.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
Yes
Supports:
No
Resolution:
.15
Infill:
100%
Filament: eSun PLA+ White
Notes:
100% infill is probably not required but it is only ~10g per strip even at 100%. I printed these with 4 walls and line infill. I doubt those settings make any difference but it is my typical PLA+ settings anyways. I printed with a small brim just to stabilize it a bit.
Print to your preferred material and settings but I do suggest .15-.20 resolution otherwise the cells get a little wonky.
Category: DIY