1 / 5
50 mL Centrifuge Tube Horizontal Shaker Clamp — zdjęcie 1
1 / 5

50 mL Centrifuge Tube Horizontal Shaker Clamp

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mounts standard 50 mL conical tubes horizontally on shaker platforms; M4/#10 mounting, optional anti-sag support.

Ocena
0 / 5
Polubienia
5
Pobrania
17
Wydruki
0
Wyświetlenia
282
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

50 mL Centrifuge Tube Horizontal Clamp for Shakers

A simple, sturdy clamp for mounting standard 50 mL conical (Falcon-style) centrifuge tubes horizontally on a mechanical shaker. The design supports even, side-by-side shaking and reduces tube sag for more comparable mixing between tubes.

Included STL files

tube_clamp_bottom.stl

tube_clamp_top.stl

tube_horizontal_support.stl (optional; slides over tube ends to prevent sagging)

round_spacer.stl (optional; use if your mounting bolt is longer than the platform thickness)

 

Hardware (per clamp)

2× M4 hex bolts

1× M4 lock nut (for the hinge/pivot)

1× M4 wing nut (for quick closing)

1× mounting bolt or screw for your shaker platform (M4 or #10 are at least supported)

 

Compatibility

Mounts to platforms using M4 or #10 hardware.

Confirmed to fit the IKA IO SP 25 shaker platform (M4 holes).

Confirmed to fit the New Brunswick Scientific G10 Gyrotory Shaker (#10 holes).

 

Assembly

Join tube_clamp_bottom and tube_clamp_top with an M4 hex bolt + M4 lock nut to form the hinge.

Use the second M4 hex bolt + wing nut as the front fastener to close the clamp around the tube.

Fasten the clamp to your shaker through the base using an M4 or #10-24 bolt/screw. Add round_spacer.stl as needed if the bolt is too long.

(Optional) Slide tube_horizontal_support.stl onto the tube ends to keep them level during shaking.

 

Printing notes

Material: PETG or ABS/ASA recommended (better heat/chemical resistance than PLA).

Layer height: 0.2–0.28 mm

Infill: 15% (gyroid/cubic)

Orientation: Print tube_clamp_top.stl and tube_horizontal_support.stl flat on their back faces. Print tube_clamp_bottom.stl and round_spacer.stl standing upright. Use organic/tree supports touching the buildplate for the bolt holes in tube_clamp_bottom.stl.

 

Use notes

Designed for homogeneous shaking dynamics when the same liquid volume is used in both tubes.

Always verify clamp tightness before running the shaker. Not intended for clinical or safety-critical use.

Tagi