Lighthouse

I couldn't find a lighthouse model I liked, so here's what I came up with. I don't have a MMU, so I have it broken up by color (solid model included as well if that suits your fancy). Everything is made to print vertically without supports. The bottom of the base section (section 1) has a cavity so you can pause the print and add a magnet. It should still print fine if you don't with minimal impact on the infill. Each section keys together to make fitting/gluing easier. The section 5 sleeve is made to glue in to section 4. Section 5 can then be glued into section 6, allowing for the roof to be removed. The battery/light holder is made to hold a CR2032 battery which you can slide an LED over. The two holes are for looping over a piece of filament as a handle. If you don't plan on adding a light, you can skip the sleeve, though it does help alight section 5 to section 4.