Polymaker Polydryer 1.75mm PTFE Retainer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple retainer to keep 1.75mm PTFE tubes from being pulled inside the Polymaker drybox with the stock silicone plugs
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 1
- Wyświetlenia
- 240
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
While using the Polydryer system with my MMU3 I would occasionally have times where the PTFE tube would be pulled up into the drybox when printing. To help with this, I made this simple retainer that can be glued on to the inside of the top lid or container body over the top of the stock silicone plug to prevent the PTFE tube from being pulled through, while still allowing filament to easily pass.
I have noticed that it does not grip the PTFE as firmly as before (since you are not running the PTFE all the way through the silicone plug) so they pull out easily but for me it was enough to stay in place while printing.
To attach, apply a small dab of super glue to each of the 3 tabs then place it over the installed stock silicone plugs and press firmly against the inside wall.
I have attached both the STL and STP in case you would like to modify your own.