1 / 1
Freezer Door Shelf for JennAir 42" Built In Refrigerator
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Freezer door shelf for my JennAir JS42NXFXDE. I believe the part number is Whirlpool #W10594374.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 62
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
Wanted to add a couple shelves to my JS42NXFXDE JennAir fridge/freezer. I believe the part number is Whirlpool #W1059437. They will sell one for about $140 which was annoyingly expensive, especially after how much these dumb builtins cost in the first place.
Modeled my own and made a couple versions - a full size replacement and a half height ledge replacement.
Print instructions:
- Pick which shelf you want and load the two parts
- Copy and then mirror the copied bracket across the X axis to make a right side bracket
- Print both brackets and the shelf. Shelf should be printed on its front face. These are sized for a Bambu P1/X1 - you will have to rotate the ledge shelf and print it diagonally, I was able to make it longer and the brackets smaller which looks nicer and gives more space.
- NOTE: The bracket requires supports just to make the one recessed ledge line print nicely. I also changed the bridge direction on the bracket to 45 degrees to make it print better.
- Sand or file the edges of both pieces where they connect to improve adhesion, and superglue them together.
- It should sit nicely in the freezer. If it's slightly off, you can heat up the bracket wherever you think it's hitting oddly and try and melt it into a better fit - I had to do that for my ledge shelf, but then I made it 1mm smaller so these files should fit nicely.
- I included the scad files if you want to edit something, but they aren't exactly pretty.