PETG Tungsten 75% Shielding Spiral
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An attractive spiral that acts as a jig for testing the radiation shielding abilities of Prusament Tungsten 75% PETG.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution — Share Alike
3D printable radiation shielding creates a lot of interesting possiblities for irregularly shaped objects that wouldn't be possible through traditional manufacturing techniques. This spiral acts as a continuum of different shielding thicknesses that can be used to demonstrate various concepts like energy-dependent attenuation, Compton scattering, K-edge absorption, and many more.
The shielding thickness ranges from 0.5mm to 7mm, with the small notches on the inside marking the aproximate location of each whole millimeter (1mm, 2mm, 3mm, etc.). The outer spiral is 1 inch wide and is intended for use with isotope disk sources like those from Spectrum Techniques.
Attenuation of Cs-137 gammas throughout the range of the shielding spiral; Pruasment PETG Tungsten 75% - 100% infill.
This model uses approximately 54g of material when printed in Prusament PETG Tungsten 75% filament at 100% infill. Make sure to print the calibration block first to ensure your printer is up to the task of printing this exotic filament.