Door hinge for Motedis 3030 B-Type extrusion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Door hinge made for Motedis 3030 B-Type aluminium extrusions. (or other frames that are 30mm wide) I wanted hinges…
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 88
- Wydruki
- 2
- Wyświetlenia
- 854
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Door hinge made for Motedis 3030 B-Type aluminium extrusions.
(or other frames that are 30mm wide)
I wanted hinges that would attach the door flush against the frame. The only ones I had on hand or could source locally left a gap of a few mm so I made these as a temporary solution.
I've been using them for a while now and so far no signs of wear and tear so I might just stick with them.
Just to put it in perspective the door is 680mm high and 600mm wide and carries a 5mm acrylic sheet window. Not sure about the weight but it does weigh a bit.
Specs:
Width: 60mm
Length: 75mm
Height: 8.5mm
Uses four 6mm screws and a 75x8mm dowel pin.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20-25%
Category: DIY