Coolermaster NR200/NR200p SPC vertical pump mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
So I decided to transplant my old loop with an EKWB A240G aluminium loop into an NR200p. Seeing how it is recommended…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 1164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
So I decided to transplant my old loop with an EKWB A240G aluminium loop into an NR200p. Seeing how it is recommended to have a EK-XRES 100 SPC-60 MX PWM (incl. pump) in the vertical orientation (according to the manual). I decided to make a bracket to keep it as such.
The case already had holes drilled to keep it in a horizontal orientation, so it was a matter of making a small plate with the holes in the right space (50mm distance between them) and making a panel with the same holes attached to it in a 90 degree angle.
It has a bit of flex downwards, could perhaps be supported even better, but it can keep the pump up without worries when the reservoir is entirely filled.
Attached the pump to the bracket and the bracket to the case via
- 8x polyamide washer M4
- 8x screws M4x6
- 4x nut M4
These happened to be screws I had laying around from a EK-UNI Pump Bracket. Washers are optional (but they were included with the screws and I did not want to lose them.
In the pictures you can see my original version. In which I had to make some adjustments, this is already corrected in the uploaded model.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Filament: 123-3d Jupiter PLA Grey
Category: Computer