Head holder Kenwood TH-D710
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
A attempt to make a new holder for the "head" of my TH-D710. This is the first part of two that will be used to easily mount the radio in the cars I have so I don't have to move the head bracket.
Not exactly easy to print as everything is very thin on the back wall so I had to make a couple of support legs on the back to keep it from breaking off.
On the plate under the "head" there is a V groove that should be pushed into the holder that is stuck. A separate part will come for it later too.
Printed with PETG 0.2 and 75% infill to make it as strong as possible without it becoming brittle.A little attempt to make a new holder for the "head" of my TH-D710.
This is the first part of two that will be used to easily mount the radio in the cars I have so I don't have to move it at parties. Not exactly easy to print as everything is very thin on the back wall so I had to make a couple of support legs on the back to keep it from breaking off. On the plate under the "head" there is a V groove that should be pushed into the holder that is stuck. A separate part will come for it later too.
Printed with PETG 0.2 and 75% infill to make it as strong as possible without it becoming brittle.