NiteBow Nose Cone for 38mm Body Tube
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Does anyone still have an old NiteBow sitting in a box somewhere without a rocket? Why not put it on top of the…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 137
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Does anyone still have an old NiteBow sitting in a box somewhere without a rocket? Why not put it on top of the ubiquitous 38mm rocket body? (don't forget to extend your launch lugs out a few mm)
The eye bolt is (probably) a #8 or #10 thru - it came out of the parts bin.
The four mounts for the lower board are for #4 coupler/extension nuts and need to be heat-set (hexagonal opening is slightly undersized when printed).
And, of course, you'll want to throw a bit of foam or wadding next to the battery to keep it from wandering a bit during aggressive flights.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
No
Resolution:
200
Infill:
25
Filament: eSun PETG Black/Clear
Notes:
The base can be printed in any color, but the cap should be in a clear or translucent filament (for obvious reasons)
Category: Other