1 / 5
Surround Cooling Duct for Ender 3 V3 SE - 5015 Fan Upgrade — zdjęcie 1
1 / 5

Surround Cooling Duct for Ender 3 V3 SE - 5015 Fan Upgrade

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Upgrade to the Ender 3 V3 SE with this adjustable 270° cooling duct designed for a 5015 blower fan.

Ocena
0 / 5
Polubienia
24
Pobrania
185
Wydruki
0
Wyświetlenia
1058
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I designed this 270° cooling duct for the Ender 3 V3 SE to improve part cooling with a 5015 fan. It was planned for 360° airflow but because of the BL-Touch sensor, I had to make some clearane for it.

Adjustable height allows you to slide the duct up or down to suit your needs, will also work with KE printers and printers with modded hotends (ceramic hotends).

Internal fins guide airflow to the nozzle, and the smoothed-out interior ensures efficient cooling.

 

Key Features:

  • 270° Coverage: Airflow wraps around the print from all sides
  • Adjustable height: Directs airflow to the nozzle and print area for targeted cooling.
  • 5015 fan Compatibility: Mounts a standard 5015 blower fan for stronger performance than the 4010 stock fan.
  • Lightweight design: Print only weighs around 25 grams (PETG)

Print Settings:

  • Material: PETG, ABS, PLA (Optional, but prone to warping when printing with a very hot bed.)
  • Nozzle: 0.4mm
  • Layer Height: 0.2mm
  • Infill: 15 - 30% 
  • Supports: Yes (*NB: Make sure supports are set to build plate only.)(*NB: Make sure supports are set to build plate only.)
  • Print Orientation: Base down for Stability (but you can experiment with other orientations.
  • Print Time: ± 2 - 3 hours (depending on speeds and material)
  • Filament Usage: 20 - 30 grams

 

Assembly:

  1. Print the duct.
  2. remove the stock fan shroud from the Ender 3 hotend.
  3. Attach the duct to the side mounting points using the original screws from the old fan shroud.
  4. mount the 5015 fan to the duct using a 3mm heat insert or a long enough m3 screw with a nut to secure it in place.
  5. Wire the fan to your printers original fan header
  6. Test airflow and adjust fan speed in your slicer for optimal cooling without over-cooling the heater.

 

Parts Needed:

  • M3x20 mm screw
  • M3 nut/ M3 Heat insert (you can go with either option that best suits your needs)
  • 5015 24V fan.
  • Some miscellaneous tools, screwdriver, soldering iron (if replacing with 4010 fan, you can clip of the JST header and solder on to the 5015's wires.)

Tagi