1 / 4
Holder for remoulade bottles / Halter für Remouladen-Flaschen — zdjęcie 1
1 / 4

Holder for remoulade bottles / Halter für Remouladen-Flaschen

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Upside down holder for Danish remoulade bottles (P&W) / Halter zur kopfüber Lagerung von dänischen Remouladenflaschen

Ocena
0 / 5
Polubienia
1
Pobrania
6
Wydruki
0
Wyświetlenia
33
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution

I hate containers for viscous substances that you can't turn completely upside down to empty them, as you never get everything out.

One example is the plastic bottles for Danish rémoulade. I often use the 900g bottles from P&W, which have a diameter of approximately 81 mm.
I designed a simple holder for this bottle that allows you to place it upside down on the dining table and simply store it in the refrigerator door.

I can't say whether the holder will fit other, similar bottles, but the diameter can be easily adjusted in the slicer (scale x and y) if necessary.

The holder is designed so that the cap is automatically centered in the holder, so the bottle always stands perfectly upright.
If necessary, three 10mm diameter silicone pads can be glued to the bottom as feet to protect scratch-sensitive surfaces.

Note: The holder shown on the photos did not yet have the side grip recesses.

Print with any filament (I used Elegoo PLA beige), no supports required.

----------------------------------

Ich hasse Behälter für zähflüssige Substanzen, die man nicht komplett umdrehen kann, um sie zu leeren, da man so nie alles herausbekommt.

Ein Beispiel sind die Plastikflaschen für dänische Remoulade. Ich verwende oft die 900g Flaschen von P&W mit einem Durchmesser von ca. 81 mm.
Ich habe dafür einen einfachen Halter entworfen, mit dem man die Flasche auf den Esstisch stellen und einfach in der Kühlschranktür verstauen kann.

Ob der Halter auch so für andere, ähnliche Flaschen passt kann ich nicht sagen, aber der Durchmesser lässt sich ja ggf. leicht im Slicer anpassen (x und y anpassen).

Der Halter ist so konstruiert, dass die Verschlusskappe im Halter automatisch zentriert wird, so dass die Flasche immer  genau aufrecht steht.
Am Boden können bei Bedarf 3 Silikonpads mit 10mm Durchmesser als Standfüße eingeklebt werden, um kratzempfindliche Oberflächen zu schützen.

Anmerkung: Der auf den Fotos abgebildete Halter hatte noch nicht die seitlichen Griffmulden.

Druck mit beliebigem Filament (ich habe Elegoo PLA, beige verwendet), keine Supports erforderlich. 

Tagi