1 / 6
BMW R80 R100 Seat Lock (Sitzbank Verriegelung) — zdjęcie 1
1 / 6

BMW R80 R100 Seat Lock (Sitzbank Verriegelung)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This part is no longer available from BMW. I needed it to undo a "custom" rear subframe. Replicas are way too expensive.

Ocena
0 / 5
Polubienia
0
Pobrania
16
Wydruki
0
Wyświetlenia
121
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

I had to undo a “custom” rear subframe and I was missing the seat lock. Tested on 1993 BMW R100GS. Should fit other 247E-framed BMW models as well. That part is no longer available from BMW directly. And it is not that comlicated. It could also be done with a simple 2mm aluminium plate. You need additional hardware. I used a M6 spring plunger. Look for “ZYAMY 4pcs Spring Plunger M6 Stainless Steel Non-Locking Short Column Manual Telescopic Spring Plunger with Pull Ring” on amazon.com or "Federstößel mit Zugring, Sicherungsstift aus Edelstahl, einziehbarer Rastbolzen für Industrieanlagen(M6)" (amazon.de).

You need two m5 bolts or 4.8mm rivets so secure the part to the frame.

Print it, tap it (not necessary) and screw in the spring plunger. The lock nut sits on the inside. Adjust to your seat - there is some wiggle room. 

Do not (!) slam on the seat like ou can with the original construction. Pull the plunger, lower the seat, release the plunger. It does not lock like the original. But it only costs 5,- to make in contrast to 180,- for the (used) original part.

 

Tagi