Hoover Senior/Ranger/Commercial 652 6525 U4000 etc. Beutelflansch / bag flange
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Beutelflansch für die alten Hoover-Klopfsauger / Bag flange for the old Hoover vacuum cleaners
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 1
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
----for english, please scroll down----
Beutelflansch (das Unterteil des Staubbeutelbehälters, das am Sauger angesteckt wird) für die alten Hoover-Klopfsauger der Senior-, Ranger- und Commercial-Serie. Der Flansch hat einen Kunststoffpin, der bei mir nun zum zweiten Mal abgebrochen ist, da die Nachbauflansche zwar viel kosten, aber wenig taugen.
Daher hier zum Nachdrucken und bei der Gelegenheit auf eine zweiteilige Konstruktion geändert, damit man den Haltepin einzeln wechseln kann. Es werden noch zwei Senkkopfschrauben mit 2,5…3mm-Gewindedurchmesser benötigt
Hinweise zum Drucken:
- gedruckt mit einer 0,4mm-Düse, 4 Perimetern und 6 massiven Top- und Bottom-Layern sowie 25% Infill.
- Der eigentliche Flansch wurde aus Engineering-PLA gedruckt und benötigt zwingend Supports!
- Das Teil mit dem Pin wurde stehend aus PETG gedruckt, damit die Layer nicht den Pin schwächen.
------------
Bag flange (the lower part of the dust bag container that attaches to the vacuum cleaner) for the old Hoover Senior, Ranger, and Commercial upright vacuum cleaners. The flange has a plastic pin that has now broken off for the second time on my vacuum, as the replacement flanges seem to be of high price but mediocre quality.
Therefore, here is a model for printing, which I have changed to a two-part design so that the retaining pin can be replaced individually. Two countersunk screws with a thread diameter of 2.5–3 mm are also required.
Printing notes:
- Printed with a 0.4 mm nozzle, 4 perimeters, 6 solid top and bottom layers, and 25% infill.
- The actual flange was printed from engineering PLA and requires supports!
- The part with the pin was printed upright from PETG so that the layers do not weaken the pin.