Ryobi 10" Table Saw Bevel Lock Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Redesigned Bevel Lock for the Ryobi 10" Table Saw
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 130
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The stock bevel lock handle on the Ryobi 10" tablesaw is a awful design, its spring loaded faux ratchet mechanism makesThe stock bevel lock handle on the Ryobi 10" tablesaw is a awful design, its spring loaded faux ratchet mechanism makes locking a specific angle difficult at best and impossible at worst, it also is a plastic socket which strips easily when tightening it. Take off the current bevel lock, remove the grey hex headed cylinder, spring and washer, and swap them into the print then voila.
Print settings: 75% infil, gyroid, 0.2mm layer height, print with supports. Used PETG but any rigid material works
Handle works for the following
Handle is a replacement for