[Parametric] Water Bottle Stabilizer

I kept knocking my water bottle over and spilling water everywhere, causing panic in myself and my cats, so I made this water bottle stabilizer.  It's pretty simple - holds the water bottle and adds a brim to keep the bottle's center of gravity above a support.

STL, SCAD, and 3mf files provided.  No supports necessary for printing.

The model is parametric, so you can adjust it to fit your needs using OpenSCAD or a similar program:

• inner diameter (71mm default):  The diameter of the water bottle you want to stabilize (plus a small margin).
• wall_height (35mm default):  The height of the walls holding the water bottle.
• wall thickness (2mm default):  The thickness of the walls holding the water bottle.
• brim width (25mm default):  The width of the brim to add.
• brim thickness (2mm default):  The height of the bottom of the stabilizer.

The following 3mf files are provided:

• 71 mm
  • Designer Validated:
    • Good & Gather 23.7 fl oz
  • Community Validated:
    •  
  • Likely But Untested:
    • Smart Water 23.7 fl oz
• 69 mm
  • Designer Validated:
    • Niagara 16.9 fl oz
  • Community Validated:
    •  
  • Likely But Untested:
    • Other 16.9 fl oz
• 68 mm
  • Designer Validated:
    • smartwater 20 fl oz
  • Community Validated:
    •  
  • Likely But Untested:
    • Other 20 fl oz

Drop a comment to let me know which brands work with which sizes or if you need a size uploaded that's not currently available.

All models uploaded to Printables are uploaded with a free Personal Use License.  Commercial Use Licenses are available to Supporters/Distributors on Patreon.

[License Details] [Patreon Memberships]