Wanhao I3+ Cocoon filament spool holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have a variety of filament spools, some have only a 10mm hole, most are wider than the holder, I also wanted a guide…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 236
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I have a variety of filament spools, some have only a 10mm hole, most are wider than the holder, I also wanted a guide and tension control for the filament, these have a couple of holes underneath the front that take 6mm of a 3mm screw thread.
Clips work surprisingly well, I did 3 test parts before settling on a 1mm clearance.
Added a kit for half rollers, if you have a failed one then print a single.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:
No
Supports:
Yes
Resolution:
0.3
Infill:
20%
Notes:
I used PLA for this one, printed the mounts on their sides to get strength in the front clip, I might do a version 2 and reduce the size of the sides which is not needed imo, the rollers should hold the filament reel steady.
Post-Printing
File pulley halves for a few seconds to remove high spots and superglue together.
Smoothed inside edges of holder and pulleys slightly till they were nice and smooth.
If you want to use the screw holes (designed at 2.5mm) I ran a 3mm drill/tap in a pin vice and had a great result for a tapped hole in just a few seconds per hole. These holes are for the filament guide, which is yet to be designed, gimme a day or two.
Category: 3D Printer Accessories