1 / 1
Toolless Tensioner Cap for the LockSleeve SCAR — zdjęcie 1

Toolless Tensioner Cap for the LockSleeve SCAR

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Make it easy to keep your strings taut

Ocena
0 / 5
Polubienia
3
Pobrania
7
Wydruki
0
Wyświetlenia
80
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Outdoor Toys
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Toolless tensioners for the LockSleeve SCAR so you can tie sloppily and tighten it afterwards. 

Use 8mm m3 screws to secure the tensioners against the cap such that they can be adjusted by hand but take some force. longer ones won't fit and shorter than 6mm may not thread into the cap enough.

Strings easier by doing it the "wrong" way. Take string 2 times the length of the SCAR with a few inches of excess (the more, the easier) and feed both ends through the body and out the vents, then feed them back through the vents to the cap. Wrap them a few times around the tensioners and then through the tensioner, then tie them with a large enough knot to prevent it from slipping through (overhand knots using both worked for me). I recommend wrapping them all clockwise to make it easy to remember which direction to tighten/loosen them.

Done for the LockSleeve SCAR since it strings plenty easy this way and is more repairable compared to the QuickString SCAR.

Tagi