CFD-Optimized Dual-Horn Fan Duct for Sovol SV06
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Validated by CFD and water tests, it delivers precise cooling around the nozzle tip
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 42
- Wydruki
- 1
- Wyświetlenia
- 218
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a CFD-optimized model cooling fan duct for the Sovol SV06, offering improved cooling performance.
It is specifically tuned for pinpoint cooling airflow orientation just under the nozzle, making it ideal for slow-to-mid-speed (e.g., 100 mm/s), high-quality printing that enhances the SV06’s strength in delivering fine details.
The duct keeps a consistent cross-section from the fan inlet to a few millimeters before the duct tip, minimizing pressure loss and turbulence.
It is split into a front duct and a rear fan mount, connected with three M3 countersunk screws. The fan mount is interchangeable, supporting both the stock 4010 fan and the optional 5015 fan, allowing users to choose between reusing the original fan or upgrading to stronger cooling.
Result of CFD Analysis
CFD shows airflow focused directly beneath the nozzle. The duct generates a narrow, pinpoint flow tailored for high-quality, slow-to-mid-speed printing. While wide airflow designs are often used for very high-speed printing, this design intentionally concentrates cooling for maximum detail quality.


The airflows are slightly offset, with a main front exhaust and secondary rear exhaust to reduce turbulence around the model. Unlike many ducts that show internal turbulence in CFD, this uniform cross-section design keeps internal turbulence minimal, producing a stable, smooth jet.


Result of Test
On the test visualizing airflow using a water surface, the airflow focused around the nozzle tip, creating a symmetrical dimple and showing a stable, turbulence-free jet.
Bill of Materials (BOM)
Cooling fan
- 1 × 4010 (reused from SV06) or 5015 (NEW) blower fan
- 1 × JST-ZH-2 pin and housing (for 5015 fan)
New screws
- 3 × M3×8 countersunk screws (NEW; for jointing parts)
- 2 × M3×20 countersunk screws (NEW; for rear mount)
- 1 × M3×20 cap head or button head screw (NEW; for mounting 5015 fan)
Reused screws
- 2 × M3×5 screws (reused from SV06; for front mount)
- 2 × M2×6 screws (reused from SV06; for mounting 4010 fan)
Printing Notes
- Recommended materials: ABS, ASA, or other high-temperature resistant filaments.
- PETG: may work, but limited durability.
- PLA: not recommended — will deform quickly from bed heat (failed in my test).
- Orientation: as provided (no supports required) see picture below

Assembly
See pictures below.

Additional Notes
- Optimized to highlight print quality and fine detail at slow-to-mid speeds.
- For high-demand cooling, prefer the 5015 version.
- Recommended fan: GDSTime high speed dual ball bearing 5015 blower fan.
Winsinn same spec is weaker cooling than it in my impression.