Wall mount for OPNsense DEC600 (DEC677 and DEC697) series firewall
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These four feet slide over the heatsink grills of the DEC600 series firewall to allow you to wall mount it.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
OPNsense at this point in time does not sell a wall mount for the DEC600 series, only for the DEC700 series, which is not compatible with the DEC600 series.
So I created these feet to serve as wallmount.
You print two pair of them, one type goes on the bottom, the other on the side. Both slide on the firewall from the side, the bottom ones over the last thick fin, the side ones in between two fins.
The screw holes are sized for T15 Spax screws which have a 4mm diameter shaft, 6.8mm diameter and 3.2mm thick head.
I printed them in PETG with 100% infill, but I imagine they should work just as well with PLA and/or less infill.
The model was designed using solidpython2 compiled to openscad.
If you want to modify the model you'll also need my solidpython library at https://github.com/bernieke/solidpython-library