5VZ-FE MAF housing (1995-1998ish)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My Denso original started acting up, so I redesigned it for much more common MAF sensors.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 220
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial
The original Denso sensor went out. Reverse-engineered it so I could use the much more common Denso sensors from newer models that have the 5VZ-FE motor. Fits the 1995-1999ish models, mine was made for a T100.
You need
M6 het set inserts,
M4 heat set inserts
M4 x8mm (up to x12 should work)
Willingness to repin your connector or get an extension. I used a URD MAF harness extension and repinned it to fit my T100.
You'll need a Denso sensor that fits, one that would go on a V6 Tacoma or 4Runner year models, something like 2000-2004.
Mine is printed out of Siraya tech fiberheart ASA GF. There's plenty of material options, but I'd say PLA or the like is a bad choice inside the engine bay for long-term survivability. The gasket is TPU, but a different flexible material should also work.