1 / 7
Dayton BDS Exciter Mounts for Heusinkveld Sprint Pedals — zdjęcie 1
1 / 7

Dayton BDS Exciter Mounts for Heusinkveld Sprint Pedals

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remixed ones made for Simagic P-HPR to fit Heusinkveld Sprint Pedals. Brake and Accelerator only, no clutch.

Ocena
0 / 5
Polubienia
2
Pobrania
9
Wydruki
0
Wyświetlenia
166
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Video Games
Licencja
Creative Commons — Attribution — Noncommercial

Use Dayton BDS Exciters on your Heusinkveld Sprint Pedals. Use the IMS adapter that came with the exciters.

Extra Hardware Required (per pedal):

Reused from your Heusinkveld Sprint Pedals (per pedal):

  • Long Hex Nut (1x)
  • Side Bolts (2x)
  • Short Hex Nut (1x)

Printing Guidelines:

  • For better vibration transmission I maxed out shell layers
  • Walls: 4
  • Bottom Shell Layers: 999
  • Infill: 0%
  • Layer Height: 0.2mm
  • PETG recommended

Assembly Instructions:

  1. Disassemble your Heusinkveld pedal that you are intending to modify.
  2. Take the long hex nut from the HE pedal and insert it into the printed adapter. This will be a tight fit. That's by design to maximize the conduction of the vibration, and minimize any chance of a rattle. Screw in a bolt to help you push it in, if needed.
  3. Inserting the short nut: 
    1. Take the 25mm bolt and insert it through the front. 
    2. Thread the flat side of the short nut onto the bolt. 
    3. Pull the bolt into its socket in the printed adapter. 
  4. Align the long hex nut hole with the holes in that pedal frame. 
  5. Carefully thread the side bolts into the long hex nut through the frame. You may need to jostle the adapter a little to find the right alignment. Take your time here so you don't cross-thread anything. Tighten them down. 
  6. Mounting the pedal face:
    1. Place the pedal face into position. 
    2. Take the 25mm M4 bolt and GENTLY push it in. The goal here is to avoid popping out the hex nut. 
    3. Once you feel the bolt's end meet the hex nut, gently twist it to engage the threads.
    4. Tighten down.
  7. Secure IMS adapter from BDS Exciters to the printed part either by adhesive, velcro, or by using the screw holes with 2 screws and washers listed above.

Tagi