Samsung Galaxy S6 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a design I made inside of Blender. The back doesn't go all the way through, it's only imprinted a little bit…
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 97
- Wydruki
- 1
- Wyświetlenia
- 508
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
This is a design I made inside of Blender. The back doesn't go all the way through, it's only imprinted a little bit (water doesn't even seep through). I would recommend using ninjaflex as your filament, I am not sure if it will fit if not made with stretchy filament.
Also, make sure when you put it in the case you put the top (with the camera) in first and then the back. The bottom is a little more fragile than the top so be careful with it.
Print Settings
Printer Brand:
Printrbot
Printer:
Simple Black
Rafts:
No
Supports:
No
Infill:
35%
Notes:
Make sure to print it very slowly, I did it at a speed of 15 because otherwise the ninjaflex does not come out as well.
Category: Mobile Phone