Yamaha Fazer 600 ('98-'02) headstock bearing nut socket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Socket to tighten or release the headstock triple-clamp bearing nut on Yamaha Fazer 600 Motorcycles, 1998-2002
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 78
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This splined socket will fit the splined nuts on the head stock bearing top cap of Yamaha Fazer 600 motorcycles 1998-2002. These nuts are found just below the top triple clamp, and the socket makes it possible to use a 32mm socket and torque wrench to properly adjust the play in the head-stock bearings. It may also fit other bikes, please let me know if you try it and it does!
Printed in PLA at 100um layer height, 1mm wall thickness and 40% infill the socket was just barely strong enough, it correctly torqued up the bearings to the full preload of 57Nm, but broke apart on removal, with higher infill or stronger materials it should be possible to print a re-usable one.