Givi Motorbike Topbox replacement bumper mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacements for the rubber pads that support Givi topboxes on their frames. Supplied in a variety of lengths
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 67
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a replacement for the rubber bumpers on the rack for a Givi Topbox (circa 2006) that I made because the existing rubber ones turned to gloop or fell out over time allowing the box to rattle.
The "standard" STL should fit a box and rack in good condition but I've also made them in a selection of sizes to account for wear in the topbox and fittings and with an extended stem at the bottom so that you can grab them with pliers from underneath to made sure they seat properly. I printed then in Ninjaflex 85A which seems to work well.