Logitech G29/920 F1 Style Wheel

Just a relatively easy to print, F1-style wheel. You can assemble the parts with just glue/epoxy. Alternatively, if you want the ability to change handles more easily, you can use 4x M3 x 14 screws and 4x M3 nuts. This design was tested on a G920, but it is likely to fit on a G27/G920. Please search for instructions on removing the stock wheel, then this wheel simply attaches using the 6 centre screws. Also included are two types of button plungers to reach down and touch the stock switches. You will need 2x of each plunger length (I made these with the requirement of unscrewing the grey tops of the stock buttons on the G920). If using heat-set inserts, make sure to set them in the handles, NOT the main body/frame of the wheel.

Recommend printing with at least 35% infill for decent stiffness (Although I got away with 20%). Only use support material in the screw holes on the front face. Assemble the two-piece handles with super glue or epoxy. Do not over-tighten the hub screws.

Heat-set insert links:
Cheapest ones I could find if you're on a tight budget: https://amzn.to/4nTQpt5
These cost a little more, but you get more of them in case you need them for other projects: https://amzn.to/46FF3Sn

Footnote: For further durability, heat-set inserts can be used if you have the appropriate tools (soldering iron & a press for ensuring the inserts are straight, you can find a fully 3d printable press here https://makerworld.com/en/models/1306631-superserter-100-printable-threaded-insert-press)